How To Install Vinyl Siding 

How To Install Vinyl Siding 

When it comes to siding construction, the best material that is used is vinyl. The reason why it’s amongst the best materials is because it’s pocket friendly, it’s low-maintenance, and it’s long-lasting as well. Installing a siding is not a difficult task, and if you are good with DIY things, then this process will be straightforward. When you decide to go diy, the only cost you will incur is the cost of fabrics. Moreover, the siding installation process needs someone patient and experienced. 

Things to put into consideration when installing your vinyl siding include the following;

  1. Take advantage of the wider starter strip 

The area where the bottom panel hooks onto needs to be at least 1 in. When installing, you need to learn one rule, the lower the vinyl siding, the better it is. When you install it in this manner, it safeguards you from rain, snow and pests. When you are ready to install your vinyl siding, you must visit various suppliers. Every supplier sells two different starter sizes. One is 2-½ in, and the other one is 3-½. 

  1. Cap the corner posts 

Installing your siding using vinyl materials is an advantage and a disadvantage. The disadvantage is that mice, bees and other small animals are attracted to this material. If you want to be safe from pest infestation, ensure you cap each post. Tuck the remaining flaps and gently faucet a crease into them using your hammer. 

  1. Pull up as you nail 

Most vinyl issues occur when panels unlock; when this occurs, the wind gets a hold of them and sends them flying to the next yard. To avoid this, lay some pressure as you nail every piece, ensuring every panel is well fastened. Other than this, ensure you don’t power lift every piece, or you will put too much pressure on the nailing flange leading to wear and tear. 

  1. Overlap your top J-channels 

If your J-channel sits on top of the window or door, rainwater will fall on it. But you can stop the water from getting behind the side J-channel by creating a flap that coincides with all the various channels. 

  1. Purchase a vinyl-siding blade 

When you push through the vinyl siding using a wood blade, it will end up shattering the sides, and it will cause them to wreck. To be on the safe side, make sure you purchase a blade that has been made to cut vinyl sidings. These particular vinyl sidings are affordable, and they can be found anywhere. 

  1. Gather your equipment 

If you want to instal the vinyl siding yourself, you need specific equipment. You will need folders, a power saw and a chalk line. Ensure you have these tools before you start your construction process. Also, make sure you know how to use them as well. 


When you want to install your vinyl siding, you need to make sure you put the tips listed above into consideration so that you can come up with something substantial that protects you from pests and other environmental factors.